Transtec F7 OSD + 50A 6S for DJI HD

Transtec F7 Flight Controller OSD MPU6000 & 50A 3-6S Blheli_32 4 In 1 Brushless ESC 5V/3A BEC for DJI HD VTX SYSTEM Stack

Specification of F7 Flight Controller (for DJI HD VTX SYSTEM)
MCU:216MHz STM32F722RET6
IMU:MPU6000 Low noise power filter
Anti-Vibration silicone grommets built in
4x Uarts(1,2,4,5) with built-in SBUS inversion
4x Dshot/Proshot/Oneshot outputs(Support Bidshot)
1x JST-SH 1.0_8pin connector (G/Vbat/S1/S2/S3/S4/Current/R4)
1x GH_1.25_6pin connector for DJI HD Vtx
Vbat filtered output powerfor VTX(12V for DJI HD system)
WS2812 Led Strip support(5V output)
Backup solder pads for ESC and Vtx
Input:6~30V (2~6S LiPo)
BEC:5V 2A cont. (Max.3A)
BEC: 12V 1.5A cont.
LDO 3.3V: Max.200mA
USB Type-C connector
Software/Hardware Features
Betaflight support– Target TransTEC F7
BLHeli passthrough flashing supported by hardware
High Quality, gold plated 1.6mm thick PCB
Type-C USB connector for programming
Dimensions:6mm
Mounting Holes:5mm square to center of holes
Weight: 6g

Specification of 50A 4 IN 1 ESC
Brand name: TRANSTEC
Item name: 50A 4in1 Blheli_32 ESC
Support 3-6S input
ESC Telemetry
Current Sensor
5V 3A BEC
Mounting Hole : 30.5 x 30.5mm
Support DSHOT150/300/600 Proshot1000
Firmware: TRANSTECN_50A
Size: 45x41.5x7.5mm
Weight: 16g


Package Included:

HD Version
1x TransTEC F7 HD version Flight Controller
6x Anti-vibration silicone grommets (for M3 sized screws)
1x 8pin micro JST-SH 5cm connector, 1x 6pin connector
1 x 50A 4in1 ESC
1 x XT60 Power Cable
5 x Anti-vibration Silicon Rubber Spacer
2 x 8P Cable
1 x Capacitor