Holybro Kakute F7 HDV + Tekko32 F3 40A 6S 4in1

HolyBro Kakute F7 HDV is designed to work with the DJI FPV VTx module. The GH port available on the

board makes it much more convenient for you to connect HolyBro Kakute F7 HDV to the DJI FPV VTx, for

both signal and power.

Specifications:

Kakute F7 HDV Flight Controller

MCU: STM32F745 32-bit processor IMU:PMU6000 Barometer: BMP280 USB VCP Driver (all UARTs usable simultaneously; USB does not take up a UART) 6 hardware UARTS (UART1,2,3,4,6,7) All UARTS support hardware inversion. SBUS, SmartPort, and other inverted protocols work on any UART without “uninvert hack”. Supports serial receivers (SBUS, iBus, Spektrum, Crossfire) only. PPM and PWM receivers are not supported. TF card for Blackbox logging Dimensions: 35x35mm Mounting Holes: Standard 30.5mm square to center of holes Weight: 8g

Tekko32 F3 HDV 40A ESC

32bit ESC with BLHELI32 firmware Supports 3-6S lipo input PWM input, TLM supported Voltage output (VBAT) NO BEC Supports oneshot / Multishot / Dshot PWM Mounting holes 30.5x30.5mm Supports damped light F3 MCU, runs double faster than F051 Extra Cap needed for high current or 6s usage Dimensions: 44x37x6mm Weight: 11.6g

• Supports Betaflight, Butterflight, and Cleanflight.

• High-performance / low-noise IMU. MPU6000 with 6-axis gyro and accelerometer.

• Ready for autonomous flight: Integrated BMP280 barometer and SCL/SDA for use with external

GPS/magnetometer units.

• Dedicated bootloader button for easy firmware flashing.

• Low-profile design fits into even very compact frames.

• Input voltage 7v to 42v. Power the board directly from the flight pack, up to 6S (on “B+” pad

only).

• Automatic voltage monitoring. No need to run a separate vBat wire for voltage monitoring; the

KAKUTE F7 HDV monitors voltage directly from the power supply.

• Filtered voltage output for clean, noise-free video. 2 On-board regulators output 5V and 8V. 5V

output up to 1.5A to power peripherals such as receiver, FPV camera, or LED strip. 8V output up

to 2A to DJI FPV VTx.

• Supports BLHeli pass-through for easy ESC upgrade and configuration.

Package Included:
1 x Kakute F7 HDV Flight Controller 
1 x Tekko32 F3 HDV 40A Brushless ESC