iFlight SucceX F4 V2.1 TwinG Dual Gyro AIO

Description:
 

The SucceX F4 V2.1 TwinG // GY.RO FUSION is the NEXT-GEN flight controller you need for your next build. This FC is ready for anything with 5 uarts, 8 motor outputs, 32Mb blackbox and a powerful F4 processor to run it all.
 

With its clean intuitive layout, the SucceX F4  V2.1 TwinG makes installation a breeze with a 4 pin connector for your VTX and an 8 pin connector that allows simple plug and play connection with your 4in1 ESC.

 

But the real magic of this flight controller lies in its TWIN GY.RO configuration.

 

The TwinG uses two identical gy.ros oriented side by side with one offset 90 degrees from the other. Betaflight uses GY.RO FUSION to blend and average the information from both gy.ros to send a much cleaner signal to the PID loop controller! Less noise and fewer oscillations across the throttle band without adding any delay! Betaflight software filters can be lowered in most cases as well, which brings a significant decrease in delay.

 

With plenty of processing power and uarts, this is the perfect flight controller for long-ran.ge GPS builds. And the TwinG configuration makes it the perfect Fc for builds like macro quads, cinematic filming rigs and x-class racers that are a bit trickier to tune.

 

TwinG Gy.ro Setup

-The Betaflight target's default setting is ‘gy.ro_to_use = both’ / Gy.ro fusion is active!
 

-To check the current setting, please use CLI and type ‘get gyro’ to find the responding entry.
 

-Change the settings with ‘set gy.ro_to_use = ’ and type ‘save’.
 

-To get the most reliable performance or en.counter noise, oscillation and bent props: Please use the default setting ‘both”. 
 

-For Single Gy.ro use, please use the debugging options to find and tune for the cleaner gy.ro, but lose the dynamic fusion and averaging.
 

-BF offers the following dual gy.ro debug options: dual_gy.ro_raw, dual_gy.ro, dual_gy.ro_diff, dual_gy.ro_combined.
 

-BlackboxLog explorer graph: dual_gy.ro_raw Debugging = [0] Roll Gy.ro1, [1] Pitch Gy.ro1, [2] Roll Gy.ro2, [3] Pitch Gy.ro2.

 

-The displayed graph will show the Gy.ro_Raw reading (no filters applied), both gyros can be compared.

 

FC Specifications

 

MCU:STM32F405R6T6

 

IMU:Twins IC2689, Twins Gyros built-in(SPI)

 

OSD: AT7456E

 

Blackbox: Blackbox logging device

 

5X Uarts(1 2 3 4 5)with build-in inversion

 

8X Dshot/Proshot/Oneshot output

 

8X individual ESC power/ signal pads

 

1X Group of Gnd/Vbat/M1/M2/M3/M4/Cur/TX

 

Smart audio & Tramp VTX protocol: YES(IRC Tramp)

 

WS2812 led Strip: YES

 

Beeper: YES

 

PDB Specifications

 

Input: 2-6S(5-36V)

 

BEC: 5V/3A cont

 

FC Firmware

 

Betaflight

 

Target: STM32F405

 

FC: IFRC/IFF4_TWIN_G(STM32F405)

 

Physical

 

Mounting: 30.5*30.5mm, φ4mm with Grommets φ3mm

 

Dimensions: 36*36mm

 

Weight: 6.3g

 

Package Included:

 

1x FC F405

 

4x silicon grommets M4 to M3

 

1x 8pin