Flywoo GOKU GN F745 EVO 40A AIO stack for DJI + 600mW VTX

FLYWOO's new EVO series aims to make AIOs the new thing in FPV and looking at the features, it is hard to resist everything on one board!

This AIO uses a powerful F745 BGA chip and BLHELI_32 ESC firmware, integrated 5V/9V dual BEC, barometer, black box, WS2812LED, supports 7 complete hardware serial ports, I2C, and other functions are available all on this 20x20 board.

Perfect for ultralight quads that need a low-profile 20x20 stack that doesn't skimp on features.

Note: Works for both DJI and analog FPV setups. Note wiring configuration at the bottom of the page.

Features

• F745 BGA chip and BLHELI_32 ESC firmware
• Supports 7 complete hardware serial ports
• Integrated 5V/9V Dual BEC
• Black Box Feature
• HM600VTX

Specifications

HDF745 EVO Flight Controller

• MCU: STM32F745 32-bit processor,216MHz, 512Kbytes Flash
• IMU: MPU6000 (SPI)
• Barometer: BMP280
• Onboard LED：WS2812*4
• USB VCP Driver (all UARTs usable simultaneously; USB does not take up a UART)
• 7 hardware UARTS (UART1,2,3,4,5,6,7)
• Supports serial receivers (SBUS, iBus, Spektrum, Crossfire) only.
• PPM and PWM receivers are not supported.
• Onboard 8Mbytes for Blackbox logging
• 9V Power Out: 1.5A max
• 5V Power Out: 2.0A max
• 3.3V Power Out: 0.5A max
• Dimensions: 41x32mm
• Mounting Holes: Standard 20mm square to the center of holes
• Weight: 8.5g

Built-in 40A BL_32 4in1 ESC

• Support BLheli / BLHELI_32
• Support PWM, Oneshot125, Oneshot42, Multishot, Dshot150, Dshot300, Dshot600,Dshot1200
• Input Voltage: 2-6S Lipo
• Continuous Current: 40A
• Firmware: BLHELI_32

HM600 VTX

• Frequency: 5.8GHz 5 bands 37 channels
• Raceband: 5362-5945 MHZ
• Power: PIT/25/50/100/200/600mW switchable
• Control Mode: IRC(RX)/Button
• BAT: +7-28V Input
• Video System: NTSC/PAL
• Antenna: U.FL
• Size: 30.5mm×3.5mm×3mm
• Weight: 3g

Includes

• 1x Flywoo GOKU HDF745 EVO AIO 40A Stack + HM600 VTX