CineRun HD3 is awesome style of drone with the latest DJI Digital Air Unit high-definition FPV System, achieve capture pretty amazing cinematic footage in the 3-inch mini Quad, “ CINERUN HD3 “ is mainly used for capture crisp HD footage that CINEWHOOP flight , it’s extremely light weight design in 40% compared with “General” 5inch quad with for Gopro mounted. The whole weight only 203G, during the flight is enormous agile.

“ CineRun HD3 “ used STABLE PRO F7 35A flying tower, dual gyroscope ICM20689 works at the same time (most of the gyroscopes currently work in a single job), the feel is smooth and smooth. The stable flight eliminates the video jelly effect caused by vibrations, allowing pilots to take smoothly footage.

The redesigned frame can ensure stability, the propeller will not show in view during the flight, and the video can be completely for editing. It is also equipped with a durable and tough propeller guard, which can pass through the crowd and shoot some thrilling actions This allows the pilot more precision and control while filming

Match with sufficient power 1404 3850KV motor with 3-Bladed props, very handy for doing any motion.

“CineRun HD3 “ this is the best ready-made “ Cinewhoop “ re-engineered by professional assembled and tuned by GEPRC team. You must have it.

Specifications:

Frame	Full 3K Carbon Fiber Side plate : 1.5mm Top plate : 2mm Bottom plate : 3mm Side plate : 2mm Wheelbase : 155mm Motors: GR1404 3850KV Recommended Battery: 4S 850mAh (No inclued) Recommended Camera: for GoPro Hero 7/8(No inclued)
FPV SYSTEM : DJI FPV Air Unit	Operating Frequency: 5.725-5.850 GHz Transmitter Power (EIRP): FCC/SRRC: <30 dBm; CE: <14 dBm Min. Latency (end-to-end) Low Latency Mode (720p/120fps): <28 ms High-Quality Mode (720p/60fps): <40 ms Max. Transmission Distance: FCC/SRRC: <4 km; CE: <0.7 km Video Format: MP4 (Video format: H.264; Audio format: ACC-LC) I/O Interface: USB-C, MMCX, 3-in-1 port, microSD card slot Operating Temperature Range: 32° to 104°F (0° to 40°C) Input Power: 7.4-17.6 V, about 4-9 W Sensor: 1/3.2” CMOS; Effective Pixels: 4 M Lens: 2.1 mm, f/2.1 Shutter: Rolling shutter ISO: 100-25600 FOV: 150°(D); 122°(H); 93°(V) Dimension: 22.1 × 21.1 × 20.1 mm
STABLE PRO F7 Flight Controller	Model:STABLE PRO F7 35A MCU: STM32F722RET6 IMU: 2x ICM20689(SPI) BlackBox: 32Mb onboard Flash OSD: BetaFlight OSD w/ AT7456E chip Baro:NO BEC Output: 5V@3A Integrated LC Filter Input Voltage: 2-6S Lipo Firmware target: EXF722DUAL Size: 26x26mm board, 20mm mounting holes (M2)
STABLE PRO F7 ESC BL32 2-6S 4in1	MCU:STM32F051 Constant:35Amps Burst:45Amps Dimensions:3131mm(including the power pads) Mounting Holes:2020mm,M2 Supports Dshot1200,Proshot,Oneshot,Multishot Current meter: Yes Target: GEPRC-BL32-4IN1