iFlight SucceX-A F4 40A AIO

The SucceX-A F4 AIO(F4+40A) NEXT-GEN flight controller you need for your build. This FC is ready for anything with 5 uarts,4 motor outputs, 8Mb blackbox and a powerful F4 processor to run it all. Designed to work seamlessly with DJI’s new HD FPV system. To make things even simpler, the DJI Air unit can just be plugged into the AIO FC with the included wire harness. In addition, we added the popular and reliable USB Type-C instead of Micro USB and therefore the same standard than your DJI module.

Top Features:

• DJI Plug-and-Play - No need to solder tiny wires!

• Gyro Fusion - Zero delay Twin-Gyro filtering!

• Dual BEC 5V and 9V

FC // SucceX-A F4 AIO

• MCU: 168MHz STM32F405
• Gyro：MPU6000
• Blackbox：8MB
• Betaflight OSD: NO
• BEC: 5V 2.5A / 9V 2.5A
• Current sensor scale:  100
• Inverter for SBUS input (UART5-RX)
• Beeper pad : Yes
• RSSI input pad: No
• UARTs：5
• Motor outputs: 4
• 8 pin for DJI air unit port (10V，GND，T1，R1，GND，R2I，T2，5V)
• BLHeli32 Telemetry：RX6
• Input voltage：recommended 2-6S
• Target:   STM32F405 (CLI config necessary; Check SETUP GUIDE above)
• Mounting pattern: 30.5*30.5mm φ4mm with Grommets φ3mm
• Dimensions:   40.5*43mm
• Weight: 11.4g
• USB type-C

ESC // SucceX 40A 2-6S 4in1

Top Features:

- 8 layers double-sided PCB board

- 3oz 1.4mm thick power board

- 32bit STM32F051 MCU, 48kHz maximum clock speed

- TDK MLCC Low ESR ceramic capacitors

- Top grade NTMFS5C430NL MOSFET

Specification:

• MCU: STM32F051
• Up tp 48kHz PWM frequency
• Capacitance: 470uF/50V
• Current Sensor: Yes
• Input: 2-6S LIPO
• Constant: 40A / Burst: 50A
• BlHeli32 telemetry: Yes
• BEC: No
  
• Supports up to Dshot1200, Proshot, Oneshot, Multishot 
• Target: iFlight-BL32-4IN1
• Mounting pattern: 30.5*30.5mm/Φ3mm
• Dimensions: 43*39mm (including the power pads)

Package Includes：

- SucceX-A F4 AIO × 1

- SucceX 40A 4-in-1 ESC × 1

- Capacitor 470uF/50V × 1

- XT60 12AWG cable

- Cable for DJI Air Unit × 1

- M4 to M3 grommets × 4