Simple OSD 10Hz GPS Module V2

Multirotors → GPS Modules → Simple OSD 10Hz GPS Module V2

This is our new 10Hz GPS module that increased noise resistance and powered with a Super Capacitor to backup for more than one week.

SimpleOSD GPS module is 66 channel -163dB high sensitive urban GPS device with 10Hz refresh rate

Backup system and 3D Fix status led onboard.

FGPMMOPA6B is best civil GPS module on the world

This new B type GPS module including fine tuned Patch antenna. It's working perfect on urban conditions.

Features

MediaTek Single Chip
Dimension:16mm x 16mm x 6mm
Patch Antenna Size 15mm x 15mm x 4mm
L1 Frequency, C/A code, 66 channels
Embedded LNA and SAW filter
With Active patch antenna
High Sensitivity Up to -163 dBm tracking, superior urban performances
Position Accuracy < 3m CEP (50%) without SA (horizontal)
Cold Start is Under 35 seconds (Typical)
Warm Start is Under 34 seconds (Typical)
Hot Start is Under 1 second (Typical)
Low Power Consumption 48mA @ acquisition, 37mA @ tracking
Low shut-down current consumption 15uA, typical
DGPS(WAAS, EGNOS, MSAS) support (optional by firmware)
Max. Update Rate:up to 10Hz
UART Interface
Support AGPS function ( Offline mode : EPO valid up to 14 days )S
1 week backup time with Super Capacitor
3.3 to 5.5v supply voltage (Default 5v, need a small hack for 3.3v usage)

3.3v Hack

These modules are including a BlueLED between supply and backup capacitor for voltage dropping. You have to replace the LED with a diode for 3.3v usage. If you want to use the modules on your own 3.3v project;

Replace the Blue LED with 1N4148 or similar silicon diode.

Documents

Multirotors

Simple OSD 10Hz GPS Module V2

See also