KINGKONG Micro CC3D Flight Controller

Description

The KINGKONG Micro CC3D Flight Controller is used in the KINGKONG range of Multirotors. 

This flight controller uses the powerful OpenPilot architecture and the cross-platform Ground Control Station (GCS). The OpenPilot project is trying to make Open Source much more user friendly. OpenPilot software is designed to be used by everybody! 

A standard mini-USB cable (not included) is used to load the latest firmware and configure everything for your unique airframe.

This FC controller can be used as a replacement for a damaged one or to start you flying a new multirotor. It comes with a dampening mount.

Features:
• Powerful STM32 32-bit microcontroller running at 90MIPs with 128KB Flash and 20KB RAM.
• 3-axis high-performance MEMs gyros and 3-axis high-performance MEMs accelerometer.
• Tiny 4 layer PCB for superior electrical noise reduction and flight performance.
• Software support for Windows, Mac and Linux.
• Direct high speed USB support with no drivers required, a truly plug and play device.
• Spektrum satellite receiver support.
• Futaba S-BUS hardware support.
• Innovative Flexi-port technology for superior port flexibility.
• 4Mbits on-board EEPROM for configuration storage.
• 10 PWM outputs to servos, ESCs or for camera stabilization

Specs:
Size: 43 x 20 x 15mm
Weight: 7g

Included:
1 x KINGKONG Mini CC3D FC
1 x OpenPilot Serial Cable
1 x OpenPilot CopterControl RC Receiver Cable
1 x Dampening Mount
1 x Receiver Aerial Mount