Diatone ET 150 Class Micro Racing Drone

Description

The Diatone ET 150 is another offering from this high-quality manufacturer of micro size multirotors. If you are looking for a micro sized multirotor that is about as small as you can go whilst it remains fully and truly functional, then the Diatone ET 150 is for you.

It is large enough to run a standard brushless setup and is also capable of carrying top end FPV gear, but it is also small enough to fly around indoors as well as outdoors and it can fly through gaps the bigger machines will not fit through. It's low weight (26g frame only) means it will take the knocks and bangs the bigger machines cannot take without breaking.

The frame has been designed to be both clever and aesthetic, it has 30mm mounting holes top and bottom so that you can mount all the standard hardware. There is plenty of room both inside and on top for equipment that is readily available. The cut-outs have been strategically placed to accomodate the FPV components including the camera and antenna stalk.

Also supplied is the renown Diatone power distribution board with 5V stepdown which makes for an extremely neat installation and also aluminum standoff's, nylon fixings, nuts, fiber washers and fixing screws.

Features:
• Suits the popular SUB 200mm FPV racing class
• Ultra durable carbon fiber construction
• One piece lower plate made from 3K carbon fiber 2mm thick
• Standard 30mm bolt holes for flight controller etc
• 20mm clearance between top and bottom plates
• Integrated power distibution board (with 5V stepdown)
• Suits motors with 9~12mm mounting hole centers
• Aluminum standoff's
• Lightweight (26g frame only)

Specs:
Material: Carbon fiber
Frame Width: 130mm (motor centers)
Frame Length: 100mm (motor centers)
Frame Height: 26mm
Weight: 26g (frame only)
Motor Mounting Holes: 9~12mm

Required:
4 x 1306 2300~3100Kv brushless motors
4 x 3~3.5ins propellers
4 x 6~7A speed controllers
1 x Flight controller
1 x 800~1000mAh 2~3S lipoly battery
4ch radio system